Перегляд вихідного коду сторінки Converting Sliding Doors to Bi-fold Doors

The base of the T sits in the hole amongst the carpet edges, flush to the subfloor, while the arms of the T sit on top of the carpet and hold the edges down. This trim piece was screwed right down into the subfloor.
Notice that any time I point out attaching screws, you are going to want to drill pilot holes initial and counter-sink the screws so that you can putty over them later.
Now to body in the doorway. As mentioned above, our doorway is 5 inches thick, so two of the 1x6 boards had to be trimmed down a bit with the table observed and minimize to 81 inch lengths. To maintain the opening vast enough for the doorways, Tom had to airplane the boards a little, ultimately getting to use the Dewalt planer I bought for him for his birthday - last August. You do not want the doors rubbing on the body, but you do not want large gaps both. Never fear about getting it ideal listed here - the components that will come with the doors is [http://www.element-designs.com/catalog/sliding-door-systems sliding door closet doors] adjustable. Screw these upright boards into the wall loosely. Take your stage and make positive the boards are square. If you require to, insert shims amongst the wall and the board to get it amount and hold the board straight. Tighten down the screws, creating certain they are flush with your board surface area.
Once your two aspect boards are installed, you can install the leading board. Repeat the earlier steps by cutting the board to size, planing it if require be. You could also trim the wood with a table noticed and then sand it smooth if you will not have a planer. Which is what we've done in the previous. Then you screw in the board and shim it out if essential.
You're frame is developed! At this stage we took it all apart, gave the boards a couple of coats of paint, and then put it back again jointly. It's significantly less complicated to paint when you never have to worry about obtaining paint on encompassing locations.
Installing the trim
Now it's time to trim in the doorway. If you bear in mind back again to when you taken off the baseboard, you are going to see that the baseboard you remaining guiding is possibly sticking out at a 45 degree angle. You will need to have to minimize it back to depart room for the trim you happen to be likely to set up close to the doorway. If you have a trim tool like a Dremel Multi-Max , you can reduce the baseboard right in spot. Or you can get rid of the piece from the wall, lower it, and reinstall it. Evaluate the width of your new trim, then evaluate that exact same distance in from the outer edge of your framing board and mark that place on the baseboard. Which is exactly where you'll want to make your lower. Repeat on the other aspect of the doorway.
The higher corners of the trim are mitred and then the joints are caulked. Your vertical trim items need to be the peak of your doorway + the width of the trim piece that will sit horizontally.