Перегляд вихідного коду сторінки Substantial Information To Ficain In Move By Move Order

3A). A marginal amount (2%) of N, resulting from occasional generation of the three native SS linkages, was observed, suggesting that SS formation reaction almost statistically progressed. A small peak (symbol x) of an impurity, which was originated from R, was also observed. However, since its population was very low, the peak was ignored in the kinetic analysis below. On the other hand, the SS intermediates (R, 1S, and 2S) of Ins-A, Rlx-A, and Ins-B were separated roughly depending on the number of the blocked SH groups by using the reverse-phase column (Fig. 3B�CD). Although the peaks of the impurities ([http://www.selleckchem.com/small-molecule-compound-libraries.html high throughput screening compounds] intermediates are not homogeneous but heterogeneous ensembles having one, two, and three SS bonds, respectively. For example, the SS intermediates of Ins-A and Rlx-A having four Cys residues would theoretically contain six and three SS isomers for 1S and 2S, respectively. This can be actually presumed from the HPLC chromatograms. On the other hand, 1S of Ins-B having just two cysteine residues was a sole product. The each SS intermediate fractionated by HPLC was isolated, and the number of SS bond was assigned by ESI(+)-MS spectrometry. Relative populations of the SS intermediate ensembles of CX-397, Ins-A, Rlx-A, and Ins-B as a function of the reaction time are shown in Fig. 4. [http://www.selleckchem.com/products/CAL-101.html Selleck Idelalisib] It is clearly seen that the SS formation reaction with DHSox progresses rapidly, irreversibly, and quantitatively for all model peptides. The comparable results were obtained in the short-term oxidation experiments using different equivalents of DHSox or under [http://en.wikipedia.org/wiki/Ficain Ficain] different pH conditions (see Supporting information). Similar behaviors could also be observed for RNase A [10,12]. Reaction schemes of the SS formation for RNase A, CX-397, Ins-A, Rlx-A, and Ins-B are given in Eqs. (1)�C(5). equation(1) equation(2) equation(3) equation(4) equation(5) The second-order rate constants, k1 for R �� 1S, k2 for 1S �� 2S, k3 for 2S �� 3S, and k4 for 3S �� 4S, were subsequently determined by fitting the experimental data. The obtained rate constants (k1�Ck4) are listed in Table 1. Good agreement between the simulation curves and the plots of experimental data shown in Fig. 4 clearly indicates accuracy of the postulated reaction schemes. The obtained rate constants k1�Ck4, k1�Ck3, and k1�Ck2 for RNase A, CX-397, and Ins-A and Rlx-A, respectively, which can form the maximum of two to four SS bonds, were found to be basically proportional to the number of the free SH groups present in the reactive polypeptide intermediates except for CX-397 at pH 8.0 and 10.0. For example, the ratios of k1 vs.