Installing Ikea Pax Doors As Sliding Closet Doorways

We were being also hesitant to frame in any part of that opening at the leading. We beloved obtaining easy access all the way to the top rated of the closet. Here's a photograph that a lot more obviously reveals how the closet opening goes from top to bottom: Since there was no overhang, sliding doors or barn doorways ended up also out as an solution. We brought in about two or a few contractors, like a Door Specialist, who had zero strategies for what to do, besides probably producing customized sizing bifold doorways. (The regular six feet and 8 feet doorways wouldn't operate. The opening should've in shape 8 foot bifold doors … if we did choose to go the bifold doors route again. But since we had hardwood floors put in through the kitchen renovation, that adjusted the height of the opening to like seven ft 10.5 inches or so. No longer a regular measurement!) So, our pantry sat open, with no doorways, for like eighteen months following our kitchen renovation. This closet issue started acquiring on my previous nerve. #FirstWorldProblems. Thanks to the structure of the residence, you can see the pantry as shortly as you walk in our front doorway. It can be like greeting houseguests with, Hi, welcome to our house, Look AT OUR PANTRY Clutter.” Finally, we determined that there was no other option than to frame in a portion of the higher closet opening. Luckily we were in a position to make it nice and small, still providing us decent entry to the prime shelves, but it is harder (er, unattainable) to match anything big up there any longer. Drywall Framing for Closet Overhang The bulk of the Ikea Pax Door installation consists of a top rated monitor. Properly, due to the fact our closet had no overhang, we wanted a construction to mount the keep track of on. We enlisted the assist of Ken's stepdad, who is a handyman, to do the framing, given that that was nicely out of our comfort zone (especially if we desired it to appear wonderful). I'm not fully confident about the terminology below, so I am just going to describe what was likely on. 1st, his stepdad ordered some lumber supplies and designed a framing box” that was the width of each and every closet doorway opening. He then set up it at the prime. This is what it looked like from beneath: Then, he lower the drywall items to measurement and screwed them to the new framing. This also concerned some steel corner/edging sliding door closet doors pieces. Next up, he put a layer of mud on it. He experienced to get heading, so we waited for the mud to dry, and then did the second layer of mud ourselves and then sanded it and painted it. (Not pictured). I've gotten damn excellent at patching drywall holes, but wow, mudding an complete new drywall surface area was tricky! I produced a mess of that next coat of mud. It was genuinely uneven, even right after sanding it down. Particularly the place the framing fulfills the ceiling. In the long term, I can absolutely foresee finding that fixed skillfully. It does not look negative from a length, but it is a single of those items that I KNOW IS THERE.