) 130/90 90/90 1,250 3.7 90 130/90 90/90 1,250 two.8 90 14.6 12.6 14.two 11.Pentax GF-UC240P EG-3870UTK EG-3270UKTable 1 Specifications of echoendoscopes.14.three 12.8 130/130 120/120 1,250 three.812 10.8 130/130 120/120 1,250 two.8Fig.

Матеріал з HistoryPedia
Перейти до: навігація, пошук

Before the bench simulation, the diameter of each and every needle was accurately measured by a digital micrometer caliper (MDC-25, Mitsutoyo, Kanagawa, Japan).Array of angulation of Ponesimod web echoendoscope distal ideas and consequent angulation of needlesWe measured the maximum achievable angulation for every single feasible combination in the five echoendoscopes as well as the four 19G needles. The maximum distal tip "up" and elevator "up" settings had been utilised. Therefore the "big knob" (up-down) and not the smaller knob (left-right) of the echoendoscope was utilized. This was set at 0?and at maximum in every echoendoscope as well as the elevator was set at 0?and 90?(maximum). When the tip with the needle was flexed, the angle between the echoendoscope and the sheath on the needle was measured. The echoendoscope angle along with the needle angle, were defined as " angle A and angle B, respectively, as shown in Fig 2. Optimal angulation was defined as angle A and angle B getting extra than 90?and 110? respectively. All measurements have been repeated using the title= scan/nsx016 scopes held in both " the "straight" and title= journal.pone.0077579 the "curved" positions (see Fig 1).Bench simulationThe bench simulator was designed and constructed by one of the authors (T.I.), specifically for the comparative evaluation of distinctive EUS-FNA needles as previously described [19]. The operating portion of the echoendoscope was fixed utilizing a vise, as well as the in" " sertion portion was fixed in straight Fig 1a and curved Fig 1b positions using a wooden board, vinyl chloride tubing with a diameter of 19 mm (ST-19, Toyocs Co., Ltd., Toyama, Japan), and stainless steel saddle grips. We repeated all of the tests with the endoscopes held in both straight and curved positions.Resistance of needlesThe resistance to needle advancement through the endoscope was measured employing an Autograph (AGS-H, Shimadzu Corporation, Kyoto, Japan), which has a highest tolerable force of " 1,000 newtons (1,000 N) ( Fig three). The needles have been advanced at a speed of 500 mm/min. The length of the needle insertionItoi Takao et al. Evaluation of 19G EUS needles ... Endoscopy International Open 2013; 1: E24This document was downloaded for individual use only. Unauthorized distribution is strictly prohibited.EOriginal articleStatisticsStatistical analyses were performed with StatMate III (ATMS Co. Ltd., Tokyo, Japan). Normally distributed data are presented because the mean ?regular deviation (SD). Kruskal-Wallis test as nonparametric statistic was used to compare among each and every needle resistances. A P worth much less than 0.05 was regarded as indicating a statistically important difference.Using a straight scope, the numbers of optimal settings from the distal tip as well as the elevator in the Ex-19G, ExF-19G, ET-19G, and PC19G, were 11 /20 (55 ),.) 130/90 90/90 1,250 3.7 90 130/90 90/90 1,250 2.eight 90 14.6 12.6 14.2 11.Pentax GF-UC240P EG-3870UTK EG-3270UKTable 1 Specifications of echoendoscopes.14.three 12.8 130/130 120/120 1,250 3.812 10.eight 130/130 120/120 1,250 2.8Fig. Endoscopy International Open 2013; 1: E24This document was downloaded for PF-2545920 price personal use only. Unauthorized distribution is strictly prohibited.EOriginal articleStatisticsStatistical analyses had been performed with StatMate III (ATMS Co. Ltd., Tokyo, Japan).